GD-OPD Shirt Carrier

SPECIFICATIONS:

• Woven 600D Polyester, Urethane Coated, DWR
• Adjustable two-point side straps
• Standard 5” x 8” trauma pocket included (trauma insert sold separately)
• Sewn-on mic tabs on shoulders
• Sewn-on body cam tab on chest
• Name identification and badge eyelets
• Included front pleated pockets w/pen slits
• Weight: 1.1 lbs / 0.5 kg
• Optional upgrade 8” x 10” up to 10” x 12” trauma pocket (upgrade is size-dependent as smaller carriers cannot take these pockets)
• Optional name badge velcro over the right pocket,
• Optional rear ID velcro
• Warranty: 2-year on exterior cover material and workmanship

PROTECTIVE OPTIONS:

• Soft Armor Options: Compatible with all Geary Defense Soft Armor panels
• Panel Type: Concealable
• Gear-Up Armor Options: 8”x10” up to 10”x12” trauma pocket

BODY ARMOR MEASUREMENTS: (PLEASE FILL OUT COMPLETELY)

FULL CHEST MEASUREMENT: Using a cloth tape measure, measure around the back, high under the armpits, and across the largest part of the chest. Try to keep the tape parallel to the floor and use caution not to let the tape drop across the back

ABDOMINAL MEASUREMENT: Using a cloth tape measure, measure around the largest part of the abdomen. Try to keep the tape parallel to the floor, be sure to prevent the tape from dropping in the back.

BACK MEASUREMENT: Using a cloth tape measure, measure down the length of the spine from the base of the collar (Dress, polo, or (t-shirt) to the desired panel location (bottom of the panel). This will reflect the desired length of your back panel

FRONT TORSO MEASUREMENT: Using a cloth tape measure, measure from the clavicle depression / “V” notch (at the top of the bone) located at the base of the throat down between the pectoral muscles over the sternum and abdomen to the belt. This measurement shall be taken in the seated position. This should reflect your desired front panel centered length.